Engineering, 09.03.2021 14:00, anaiah13

QUESTION 1 1.1
Amooh Siya has a savings account at CPT Bank. On ANNEXURE A is a statement for
the period 22/10/2015 to 20/12/2015. Some of the amounts have been omitted.
Use the information on ANNEXURE A to answer the questions that follow.
1.1.1
Deterinine the balance in the savings account on 22/10/2015.
(2)
1.1.2
(2)
1.1.3
Calculate the monthly interest amount on 31/10/2015.
G46.95
To prevent fraud, the bank omits the last four digits from the account
number. Give an example of a possible account number for this statement.
nd
Name the person who transferred an amount of money into this account.
(2)
1.1.4
(2)
1.1.5
Write down the number of unprocessed transaction items on this
statement.
(2)
1.1.6
The total VAT inclusive amount on this statement is R19,60.
(a) Show how this amount was calculated.
(2)
(b) Calculate the VAT amount for R19,60.
(3)

QUESTION 1

1.1Amooh Siya has a savings account at CPT Bank. On ANNEXURE A is a statement forthe p

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 19:10, justkevin1231

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

continue

Do you know the correct answer?

QUESTION 1 1.1
Amooh Siya has a savings account at CPT Bank. On ANNEXURE A is a statement for<...