Engineering, 08.03.2021 20:30, jpwalker9017

Identify the terms used for different types of automation? Anderson uses stand-alone NC units and flexible manufacturing systems in his factory which engineers refer to as

automation. Linda

uses flow and transfer lines which engineers refer to as

automation.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 19:10, Mimidj9279

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

continue

Do you know the correct answer?

Identify the terms used for different types of automation? Anderson uses stand-alone NC units and f...