Engineering, 01.03.2021 18:50, izabelllreyes

An aircraft component is fabricated from an aluminum alloy that has a plane strain fracture toughness of 32 . It has been determined that fracture results at a stress of 236 MPa when the maximum (or critical) internal crack length is 2.28 mm. (a) Determine the value of for this same component and alloy at a stress level of 354 MPa when the maximum internal crack length is 1.14 mm.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, nandalabella06

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Do you know the correct answer?

An aircraft component is fabricated from an aluminum alloy that has a plane strain fracture toughnes...