Engineering, 23.02.2021 05:30, wesleygrimes0
Design a Lap joint between plates 100× 8 mm so as to transmit a factored load of 100 kN using black bolts of 12mm diameter and grade 4.6. The plates are made of steel of grade Fe-410.
Answers: 3
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Design a Lap joint between plates 100× 8 mm so as to transmit a factored load of 100 kN using black...
History, 05.10.2019 11:30
Geography, 05.10.2019 11:30
Mathematics, 05.10.2019 11:30
Mathematics, 05.10.2019 11:30
English, 05.10.2019 11:30
History, 05.10.2019 11:30
Mathematics, 05.10.2019 11:30