Engineering, 22.02.2021 22:10, Isactuallycarter99

A solid steel shaft is to be designed to transmit 750 kW at 1,500 revolutions per minute. The steel selected is an AISI 1030, cold drawn (CD) steel. The shaft is 1 m long. Assume that the bending load on the shaft is negligible. (a) Using a factor of safety of 1.5, design the diameter of the shaft. (b) If instead of using a solid shaft, a hollow shaft with the inside diameter 0.8 times the outside diameter is used, will there be any weight saving

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Do you know the correct answer?

A solid steel shaft is to be designed to transmit 750 kW at 1,500 revolutions per minute. The steel...