Engineering, 22.02.2021 18:40, Smitheyyy973

MN Chemicals desires to run the following gas phase reaction in an isothermal, isobaric (25 deg C, 101 kPa) reactor: A(g) + 2B(g) â†’ C(g, 1) + D(g)

It is determined that the rate law can be expressed as first order in both reactants. The saturation mole fraction of C in the gas phase is 0.25. Assume that A and B are fed at a stoichiometric ratio and the total volumetric flow rate is 1.5 L/min. The rate constant is 0.035 L/(mol's). Assume that all gaseous species behave as ideal gases.

Required:
a. Is this an elementary reaction/step?
b. Write out the stoichiometric table in terms of Xa and Fao for all species.
c. What is the vapor pressure of C? At what conversion of A does condensation of C begin?
d. Write (-rA) both before and after condensation as a function of conversion, the rate constant, and the initial concentration of A.
e. What volume of CSTR is required if you desire a conversion of 90% of A?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Do you know the correct answer?

MN Chemicals desires to run the following gas phase reaction in an isothermal, isobaric (25 deg C, 1...