Engineering, 20.02.2021 01:10, k123loveme

Planifica una sesion de entrenamiento

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 19:10, kayleeemerson77

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

continue

Do you know the correct answer?

Planifica una sesion de entrenamiento...