Engineering, 15.02.2021 20:50, plewse

Damien wants to study the effect on materials let 60 after it is submerged in water for varying durations what type of graphical tool should he use

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:20, mariahmimibrooks

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

continue

Engineering, 06.07.2019 04:20, Okeh4001

An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced

Answers: 1

continue

Do you know the correct answer?

Damien wants to study the effect on materials let 60 after it is submerged in water for varying dura...