Engineering
Engineering, 14.02.2021 03:30, 7obadiah

Project: Construction and Demolition Materials in Single-Family Homes: Analyze an EPA Report Assignment directions

In this project you will consider what to do with the C&D materials after a house is demolished. Read the EPA report “Analysis of the Life Cycle Impacts and Potential for Avoided Impacts Associated with Single-Family Homes” at epa. gov and answer the questions below.

Assignment guidelines

Part 1: Write a short introduction that defines life-cycle assessment, its phases, and what C&D materials are. Label it “Introduction.”

Part 2: Answers the following questions in complete paragraphs. Label this section “Analysis.” Number your answers 1 through 4:

1. What are some of the health and safety considerations for recycled or reused materials?
2. Do you think adherence to Life Cycle Assessment is good for the construction industry? Why or why not?
3. How is demolishing a house like building a house?
4. Which process appeals to you more: Building a house or demolishing a house? Explain your opinions.
Feel free to consult other resources for more information or to help you form an opinion. If you do, please list them in a Reference section with URLs if applicable.

Submission requirements

Submit your paper electronically. It should be 2 to 3 pages long. Sentences should be complete. Define your terms. Spelling, punctuation, and grammar count.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
image
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
image
Engineering, 04.07.2019 19:10, phantomlizz3233
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
Do you know the correct answer?
Project: Construction and Demolition Materials in Single-Family Homes: Analyze an EPA Report Assign...

Questions in other subjects:

Konu
Mathematics, 30.07.2019 04:00