Engineering
Engineering, 12.02.2021 16:20, campilk5

Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoir B. The surface area of A is half of B. The area of B is 40 km2. Both reservoirs A and B are subject to a total rainfall of 50 cm and evaporation of 30 cm on an annual basis. To preserve the ecological environment in the riparian zone along the water course, reservoir A is required to release a constant flow of 0.1 m3/s to reservoir B, whereas reservoir B releases 0.3 m3/s to its downstream channel. At the present time, other than the in-stream flow requirement, there is no manmade structure withdrawing water from reservoir B. A small town of 50 000 is located near reservoir B. The per capita water consumption is 400 liters per day. The town is contemplating to use reservoir B as a water supply reservoir. a) Determine the annual water storage change of water (in cm) in each of the two reservoirs if water is to be delivered from reservoir B to satisfy the water consumption stipulated above.
b) To maintain the required in-stream flow requirement and per-capita consumption as stipulated above, for how long can this reservoir supply water to the town?
c) If the annual water storage change in reservoir B cannot be negative, how much of the percapita consumption has to be adjusted?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
image
Engineering, 04.07.2019 19:10, alex6toes
What are the major differences between injection molding and extrusion?
Answers: 2
image
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
Do you know the correct answer?
Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoi...

Questions in other subjects:

Konu
Mathematics, 15.07.2021 01:20
Konu
Mathematics, 15.07.2021 01:30
Konu
Mathematics, 15.07.2021 01:30