Engineering, 12.02.2021 01:00, foreignking02

A shaft made of AISI 1020 cold-drawn steel rotates at 1600 rpm and transmits 8 HP. (a) Using the maximum shear stress theory, determine the minimum acceptable diameter of the shaft so that there is a factor of safety of 1:8. 1 (b) Suppose the shaft still transmits 8 HP, but now the shaft rotates at twice the original speed, i. e., at 3200 rpm. Before doing a calculation, can you speculate about whether the required minimum diameter would increase, decrease or stay the same

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Do you know the correct answer?

A shaft made of AISI 1020 cold-drawn steel rotates at 1600 rpm and transmits 8 HP. (a) Using the max...