Engineering
Engineering, 11.02.2021 22:20, jasaide15

Think of the differences between circuit-switching and packet-switching paradigms in the Internet core design. Assume an Internet Service Provider (ISP) has an access link with 1500 Mbps capacity and, at any given time, only 1% of its customers are active. However, during that active period, users generate data at a constant rate of 25 Mbps. Assume that there is a total of 100 customers of this ISP. Please answer the following questions. Show your work. i. What is the probability that more than 1 users will be active?
ii. What is the probability that more than 2 users will be active?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, qwertylol12345
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
image
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Do you know the correct answer?
Think of the differences between circuit-switching and packet-switching paradigms in the Internet co...

Questions in other subjects:

Konu
Mathematics, 16.02.2021 06:30
Konu
Mathematics, 16.02.2021 06:30
Konu
Mathematics, 16.02.2021 06:30
Konu
Mathematics, 16.02.2021 06:30