Engineering, 09.02.2021 23:50, boomerjm

The one end of a hollow square bar whose side is (10.01) in with (1.01) in thickness is under a tensile stress 102,500 psi and the other end is connected with a U bracket using a double-pin system. Find the minimum diameter of pin is used according to shear strength. Take the factor of safety as 1.5 and σ_all=243 ksi for pin material.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, 1230bering

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

continue

Engineering, 04.07.2019 19:10, jennymares

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

continue

Engineering, 04.07.2019 19:10, Calliedevore

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

continue

Engineering, 04.07.2019 19:20, mercedesamatap21hx0

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

continue

Do you know the correct answer?

The one end of a hollow square bar whose side is (10.01) in with (1.01) in thickness is under a tens...