(Need answers fast !! Will give brainliest to whoever answers first !)
Pushing a button
{Choo...
![Engineering](/tpl/images/cats/User.png)
Engineering, 09.02.2021 20:10, paytonpaige22
(Need answers fast !! Will give brainliest to whoever answers first !)
Pushing a button
{Choose}
Input voltage change is detected by an input pin
{Choose}
LED blinks
{Choose}
digitalRead() command
{Choose}
PWM creates high-frequency pulses
{Choose}
map() function changes a number
{Choose}
(The options for all the questions are) :
Arduino
Code
or
User
![answer](/tpl/images/cats/otvet.png)
Answers: 2
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 06.07.2019 02:30, josediaz1124
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 06.07.2019 04:10, idjfjcjs584
Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg. k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft
Answers: 1
Do you know the correct answer?
Questions in other subjects:
![Konu](/tpl/images/cats/pravo.png)
Law, 08.01.2021 21:00
![Konu](/tpl/images/cats/biologiya.png)
Biology, 08.01.2021 21:00
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 08.01.2021 21:00
![Konu](/tpl/images/cats/mat.png)
Mathematics, 08.01.2021 21:00
![Konu](/tpl/images/cats/mat.png)
Mathematics, 08.01.2021 21:00
![Konu](/tpl/images/cats/istoriya.png)