Engineering, 09.02.2021 17:50, EwTrTw4584

An air mass usually forms in an area of. a. low pressure because its stable
b. low pressure because its unstable
c. high pressure because its unstable
d. high pressure because its stable

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Do you know the correct answer?

An air mass usually forms in an area of. a. low pressure because its stable
b. low pressure...