Engineering
Engineering, 09.02.2021 05:00, francisco42002

When preparing to begin a earth moving project that will require at least 2 years of site preparations and million tons of material has to be relocated and some blasting from solid rock
will be a part of the process. I have given you several steps that are required before and during
the process. Put them in order and give a short description of what work and preparation will
need to be completed in each step.
1. You will need to acquired the property and mineral rights or have a contract to perform
all said work described in the contract. Write down some considerations that are a must
happen before entering the property with a piece of equipment.
Call the wife and make plans for supper.
Call 811
Call the power company
Call an engineering firm.
Get in touch with the local fire department.
Get in touch with the highway department.
Get in touch with the county road department.
Check the weight limits on any bridges that have to be crossed with equipment our
trucks hauling materials.
Get in touch with the local hardware and set up an account.
Find an equipment dealership to purchase parts when needed to repair equipment.
Get in touch with the local unemployment office to set up a hiring event.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, genyjoannerubiera
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
image
Engineering, 04.07.2019 19:20, diawia
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
Do you know the correct answer?
When preparing to begin a earth moving project that will require at least 2 years of site preparati...

Questions in other subjects:

Konu
Biology, 05.05.2020 01:45
Konu
Mathematics, 05.05.2020 01:45