Engineering, 08.02.2021 20:20, horsedoggal1234
Determine the structural loads in truss members AD, AE, BE, CD, CE, and DE. b) Assuming that the truss members will all be constructed of 4130 alloy steel tubing, propose a cross-sectional geometry for each truss member that provides the following safety factors (FoS) - FoS of at least 3 against yielding, and - FoS of at least 1.5 against buckling. The cross-sectional geometry must be of standard stock sizes readily available from suppliers, such as OnlineMetals. c) Calculate the actual FoS for outer truss sections under the maximum defined loads based on your geometry selection(s). d) Estimate the material cost per truss sub-se
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
Engineering, 04.07.2019 18:10, selenamr
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Do you know the correct answer?
Determine the structural loads in truss members AD, AE, BE, CD, CE, and DE. b) Assuming that the tru...
Questions in other subjects:
Social Studies, 17.02.2021 20:10
Geography, 17.02.2021 20:10
Social Studies, 17.02.2021 20:10
