Engineering, 31.01.2021 17:00, theresamarieuehling2

QUESTION 1 angle
A truss supports the loading as shown in Figure Q1(a). Determine the magnitude of
resultant force and its angle that is acting upon the truss. Locate the distance d that
intersects the line of action of the corresponding resultant force with a line drawn through
Points A and G.
(15 marks)
+ = 12KN
o tant
'I BUL
puthn 1979864
F = 12FN custo i-
4 m
8 m
8 m
I ZEN Sin 70 J
1.2 kN
0.8KN
1 800 N
-
1.5 kN
78,97°
70
VB
VD
Faso8RN
F2 -
F3 = 1.SIN
Fly
400
0.8jKN
6 m
fo = (-1.5KN us 400 -
1.SIN sin 40 j kN)
с
IE
Gtx 4 = 0 qr
Fu = -0.9JEN
Assume R is the total
resultant force
find the equivalent force
8 m
8 m
8 m

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, mamasbug4285

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Do you know the correct answer?

QUESTION 1 angle
A truss supports the loading as shown in Figure Q1(a). Determine the magnitu...