Engineering, 31.01.2021 14:00, mashedpotatoes28

3. One liter of soil has a wet mass of 1500 g; dry mass of 1200 g, and a volume of soil solids of 450 cm3. Density of water = 1.0 g cm3. Calculate the following parameters: i. Mean Particle Density
ii. Dry Bulk Density
iii. Wet Bulk Density
iv. Dry Specific Volume
v. Porosity
vi. Void Ratio
vii. Mass Wetness
viii. Volume Wetness
ix. Water Volume Ratio
x. Degree of Saturation
xi. Air-Filled Porosity
xii. Mean Specific Gravity of the Solids
xiii. Air-Water Ratio
xiv. Solid Fraction
xv. Pie-Chart of three soil phases

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Do you know the correct answer?

3. One liter of soil has a wet mass of 1500 g; dry mass of 1200 g, and a volume of soil solids of 45...