Engineering
Engineering, 29.01.2021 01:30, 12290737

What does the following passage imply about the relative merits of the design-bid-build and design-build processes? The design-bid-build approach to construction projects is a study in unintended consequences. This approach, largely mandated in the United
States by the federal government in order to combat abuse and corruption on government projects, might have been good at blocking or
discouraging unethical practices, but it was also good at blocking project teams from reaching their full potential and developing innovative
solutions. The cure for the ills of the design-build process was higher professional standards industry-wide, not to stick a bidding step through the
middle of the process and leave construction projects to manage themselves.
The design-big-build process is not as effective as the design-build process but at least led to higher professional standards in the industry.
The design-bid-build process is the best way to combat ethical abuses and the design-build process is the best way to discourage unethical behavior.
The design-bid-build process could be as effective as the design-build process if its focus on discouraging unethical behavior wasn't so narrow.
The design-bid-build process is not as effective as the design-build process and the ethical problems of the design-build process could have been handled with better
standards

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
image
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
image
Engineering, 04.07.2019 19:10, nbug2121
Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]
Answers: 3
Do you know the correct answer?
What does the following passage imply about the relative merits of the design-bid-build and design-b...

Questions in other subjects:

Konu
Chemistry, 23.07.2019 08:00