A load of 100 N was applied to a given material. The material did not seem to deform at first but then itstarted to deform. At 10 seconds the deformation was 1mm, at 20 seconds the deformation was 2 mm, at 50 seconds the deformation was 5 mm. After 500 seconds, the material deformed 50 mm. Based onthe information given:1) What kind of rheological element can be used to represent this material

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature