Engineering, 25.01.2021 08:30, monacelli21212owlrlu

Problem #3: Bending moments and shear forces are shown below for a beam that is part of an ordinary moment frame in an office building. Determine the governing bending moments at the
ends and at mid-span as well as the governing shear forces at the ends using the LRFD Load
Combinations in ASCE 7. Assume the live load on the floor is less than 100 psf.
At the ends of the beam:
Mp=-57.6K-1
M = -22.5k-ft
Mw = +54.Ok-ft
At mid-span of the beam:
Mp= +41.1k-
M1 = +16.2k-
Mw=0.0k-ft
At the ends of the beam:
Vo = +11.8kip
V< = +4.6kip
Vw = +4.8kip

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 18:20, yasyyas646646

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

continue

Do you know the correct answer?

Problem #3: Bending moments and shear forces are shown below for a beam that is part of an ordinary...