Engineering
Engineering, 21.01.2021 23:00, gagehamel

Design a reinforced concrete cantilever beam that has a rectangular cross section with a high (h) to width (b) ratio of around 2. The beam is fixed at one end and free at the other witha span of 16ft. It carries aservicelive load of1.2kip/ft. in addition to its own weight. The design should satisfyACI 318 specifications, includingthe load factors, strength factors, minimum depth, and minimum reinforcement. The flexural reinforcement remains the same along the whole length of the beam. Use Grade

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Do you know the correct answer?
Design a reinforced concrete cantilever beam that has a rectangular cross section with a high (h) to...

Questions in other subjects:

Konu
Mathematics, 13.09.2020 17:01
Konu
Mathematics, 13.09.2020 17:01
Konu
Mathematics, 13.09.2020 17:01
Konu
Mathematics, 13.09.2020 17:01
Konu
Mathematics, 13.09.2020 18:01
Konu
Mathematics, 13.09.2020 18:01
Konu
Mathematics, 13.09.2020 18:01
Konu
Mathematics, 13.09.2020 18:01
Konu
Physics, 13.09.2020 18:01
Konu
Mathematics, 13.09.2020 18:01