Engineering
Engineering, 21.01.2021 18:30, famouzgal

The Processor X, released in 2004, had a clock rate of 3.7 GHz and a supply voltage of 1.25 V. Assume that, on average, it consumed 10 W of static power and 90 W of dynamic power. The Processor Y, released in 2012, had
a clock rate of 3.5 GHz and a supply voltage of 0.9 V. Assume that, on average, it consumed 30 W of static power
and 40 W of dynamic power.
a) For each processor find the average capacitive loads. The unit of capacitive load is called Farad (F).
b) For each processor, if the total dissipated power is to be reduced by 10%, how much should the voltage be
reduced to maintain the same leakage current?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, 19deleonl
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, pjgolden04
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Do you know the correct answer?
The Processor X, released in 2004, had a clock rate of 3.7 GHz and a supply voltage of 1.25 V. Assum...

Questions in other subjects: