Engineering
Engineering, 20.01.2021 01:00, ehuntsman8221

Write the method drawSquare below. /** Precondition: 0 ≤ x < 10, 0 < y ≤ 10, and len > 0.

* Draws a square on a 10-by-10 xy-coordinate grid

* and prints the square’s side length and area.

* The upper left corner of the square will be located

* at the coordinate (x, y) and the side length of the

* square will be len (or as large as will fit in the grid).

*/

public void drawSquare(int x, int y, int len)

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 08:10, doggo242
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, viicborella
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Do you know the correct answer?
Write the method drawSquare below. /** Precondition: 0 ≤ x < 10, 0 < y ≤ 10, and len > 0.<...

Questions in other subjects: