Engineering, 16.01.2021 15:10, connorgking

Question 1: Assume you are required to design a logic circuit enclosed in a black box to detect a password, which can be changed by an authorized administrator any time. The password is composed
of a squence of a 4-bit decimal number, i. e., each bit is in the range 'O' to '9' and sent in BCD format.
As stated above, the password should be suitable to change any time, i. e., while the initial password
can be "0120", it can also be replaced by "3456" any time by the administrator. In this design, you are
allowed to use only 4-bit parallel output shift-registers with a single-serial input data line and 4-bit
magnitude comparators. The password to detect is "1234".

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Do you know the correct answer?

Question 1: Assume you are required to design a logic circuit enclosed in a black box to detect a p...