Engineering
Engineering, 31.12.2020 19:40, lexik4746

The utility companies often sell electric power at night at much lower prices since the demand for electric power is usually much higher during the day. The owner of a four-story Hotel would like to take advantage of this opportunity. The owner decides to design a pump piping system that delivers water from the lake to the large pool (or reservoir) located on the roof of the Hotel. The owner wants to fill the pool from sea water during the night when the electric power is cheap and to use the water during the day. Therefore, the owner decides to hire a mechanical engineer to design this piping pump system to deliver the water from the close lake to the reservoir on the roof of the building. As a hired mechanical engineer, you are supposed to design this piping pump system by selecting the desired pipe size, flow rate and all necessary fittings, and determine the horsepower of the pump required for such a delivery.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, safiyabrowne7594
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Do you know the correct answer?
The utility companies often sell electric power at night at much lower prices since the demand for e...

Questions in other subjects:

Konu
Arts, 26.06.2020 16:01
Konu
Social Studies, 26.06.2020 16:01