Engineering, 29.12.2020 14:00, webbhlharryteach

a centrifugal pump delivers water at the rate of 50kg/is . the inlet and outlet pressure are 2 bar and 6.2 bar respectively. the suction is 2.2 m below the center of the pump and delivery is 8.5 m above the above the center of the pump. the suction and delivery pipe diameter are 200 mm and 100 mm respectively. determine the capacity of the electric motor considering the efficiency of motor as 80℅to run the pump.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Do you know the correct answer?

a centrifugal pump delivers water at the rate of 50kg/is . the inlet and outlet pressure are 2 bar a...