Engineering, 26.12.2020 05:50, 00manray
You are designing a critical component to be installed in a chemical plant, where corrosion resistance and high temperature performance are critical. As a result, a fully dense material is required. Because of the materials used in the system, the part can only be produced by powder metallurgy. Which powder metallurgy process would you use to produce a fully dense component?a) Hot Isostatic Pressing b) Sinter then Metal Injection Molding c) Cold Isostatic Pressing d) Press and Sinter Processes e) Metal Injection Molding
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, danksans7011
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Do you know the correct answer?
You are designing a critical component to be installed in a chemical plant, where corrosion resistan...
Questions in other subjects:
Medicine, 22.10.2019 05:00
English, 22.10.2019 05:00
