A hole drilled into a manufactured part is specified to have a diameter if 1.50 cm. Ten parts are sampled from a production run, and the average hole size is measured to be 1.57 cm. Is the average hole diameter measurement a better indicator of accuracy or precision of the drilling process.?

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Wiy doeres rere okhn a pump whon working betwon the same pressure range?