Engineering, 16.12.2020 03:40, LukeneedhelpInMath
3. (5.0 points) Using the AISC Design Tables, answer the following questions:
a. (1.25 points) What is the LRFD composite design strength of a W27x84 assuming Fy = 50 ksi, the deck
thickness is 6” and a = 4” (PNA is in the concrete deck)?
b. (0.75 points) What is the minimum edge distance from center of standard hole to edge of connected
part for a 1” diameter bolt?
c. (0.75 points) What is the minimum bolt pretension in kips for a A490 bolt that is 1” diameter?
d. (0.75 points) What is the shear lag factor for a tension member where tension load is transmitted only
by transverse welds to an angle (L
e. (1.5 points) What is the combined force ratio for a W21x55 (Fy = 50 ksi) if Pu = 50kips, Mux = 200 kipft, Muy = 0 kip-ft, Lc = 10ft and Lb = 20 ft (Using Equations from Part 16 Chapter H)
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
Do you know the correct answer?
3. (5.0 points) Using the AISC Design Tables, answer the following questions:
a. (1.25 points) What...
Questions in other subjects:
Mathematics, 20.10.2020 03:01
Health, 20.10.2020 03:01
Mathematics, 20.10.2020 03:01
