Engineering, 15.12.2020 16:20, isabella4141

When would you normally use a pin punch?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 19:20, dndndndnxmnc

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Engineering, 04.07.2019 19:20, natalie2sheffield

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference