100 ponits if answered in your own words
03.08 The Big Finish
Using the ideas you previously...
Engineering, 14.12.2020 18:20, alexdziob01
100 ponits if answered in your own words
03.08 The Big Finish
Using the ideas you previously wrote in your Narrative Organization Chart, your introduction (exposition), and the middle (rising action and climax), you will write the end (falling action and resolution) of your narrative story.
Important note: You will submit your introduction, middle, and end for this assignment.
View the grading rubric as you complete your work. This is your guide to a super submission.
Review the ideas you created in your Narrative Organization Chart, the exposition, rising action and climax of your story.
Using these ideas, write the conclusion to your narrative.
The conclusion to your narrative should be 50 words or more.
Write the events that occur right after the climax
Write a resolution with a theme (the life lesson you want your protagonist and your reader to learn)
Write in the third person point of view
Submit your entire narrative to your instructor (introduction, body, and conclusion).
To help your instructor locate your newly added ending, write the word conclusion in parentheses between the middle and the first word of the conclusion.
Save your work to your computer or drive.
Submit your work in 03.08 The Big Finish.
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Do you know the correct answer?
Questions in other subjects:
