Engineering, 13.12.2020 20:10, bobthebattlebot

During the semester, we have studied a wide range of topics related to behavior in organizations. Each module in the course began with a survey that examined your assumptions regarding its associated domain area. Material for that module either confirmed or challenged your assumptions. For this discussion forum (which is graded), choose one course module where your assumptions were confirmed and one where your assumptions were challenged.

For the module where your assumptions were confirmed:

Explain how and why they were confirmed and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways

For the module where your assumptions were challenged:

explain how and why they were challenged and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Do you know the correct answer?

During the semester, we have studied a wide range of topics related to behavior in organizations. Ea...