Engineering, 04.12.2020 21:30, TheOneandOnly003

To make a proper glue joint, you must . 10 points
a. have the surfaces rough to make the glue sink in and stick better.
b. have the surfaces wet or at least damp to help the glue sink into the surfaces.
c. have the surfaces of the wood a bit wavy to allow for pockets of glue to form.
d. have the surfaces clean and smooth for a good fit up.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 19:20, sashajayne8260

Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.

Answers: 3

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

Engineering, 06.07.2019 03:10, serenad2

Different between boring and turning?

Answers: 1

continue

Do you know the correct answer?

To make a proper glue joint, you must . 10 points
a. have the surfaces rough to make the glu...