![Engineering](/tpl/images/cats/User.png)
Engineering, 03.12.2020 21:00, judywilkerson1114
Punch that is used to make a mark in metal before drilling
![answer](/tpl/images/cats/otvet.png)
Answers: 3
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Do you know the correct answer?
Punch that is used to make a mark in metal before drilling...
Questions in other subjects:
![Konu](/tpl/images/cats/istoriya.png)
History, 24.04.2021 01:20
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/istoriya.png)
History, 24.04.2021 01:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 24.04.2021 01:20
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 24.04.2021 01:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 24.04.2021 01:20
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/himiya.png)
Chemistry, 24.04.2021 01:20