12 holes, each 10 mm in diameter, are to be machined in a 20-mm thick flange made of 304 stainless steel. Estimate (a) the recommended cutting speed, (b) drill angular velocity, (c) feed and (d) power required. (e) How long will it take to produce these holes

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.