Engineering
Engineering, 20.11.2020 14:00, mhill32

Water enters the impeller of a centrifugal pumpradially at a rate of 40cfm (cubic feet per minute) when the shaft is rotating at 450 rpm. The tangential component of absolute velocity of water at the exit of the 2-ft outer diameter impeller is 110 ft/s. Determine the torque applied to the impeller and the minimum power input to the pump.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
image
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
image
Engineering, 04.07.2019 19:20, ameliaxbowen7
List 3 options on how to reduce knocking problens during engine process,
Answers: 2
image
Engineering, 04.07.2019 19:20, diawia
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
Do you know the correct answer?
Water enters the impeller of a centrifugal pumpradially at a rate of 40cfm (cubic feet per minute) w...

Questions in other subjects:

Konu
Computers and Technology, 17.07.2020 20:01