Engineering, 20.11.2020 01:00, taehyungg

1. A simple steel pipe being used as a bracket to support equipment through cables attached as shown in Figure 1.
А
Pipe
120 cm
B
F1 = 36 kN
36 kN = F2
90 cm
30°
30°
С
12 kN = F3
Figure 1: Steel pipe
a). Select the smallest diameter steel pipe using the nearest value area calculated that
will limit the stress to no more than 124 MPa (Refer Appendix 1).
(15 marks)
b). Determine the total downward deflection of point C at the bottom of the pipe as the
loads are applied using the pipe selected in Question 1(a) (use the value area selected).
(10 marks)

1. A simple steel pipe being used as a bracket to support equipment through cables

attached as sh

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Do you know the correct answer?

1. A simple steel pipe being used as a bracket to support equipment through cables attached as show...