Engineering, 19.11.2020 19:20, Jaymp2706jj

On the handout draw the following circuits with schematic symbols. Label your answers circuit 1 and circuit 2. and circuit 3 1. A series circuit with a 6 Volt DC power supply, a switch, a lamp, an LED and a photocell.

2. A parallel circuit with an LED in the first parallel and an LED and capacitor in the 2nd parallel. Label + and - on both the battery and each components.

3. A combination circuit with a 6 Volt DC power supply, an LED in series, and two LEDs in parallel. Include a switch on the series part of the circuit and a fixed resistor on the second parellel.

When you have completed the drawings, type the word "completed" on this computer test answer space and move on to the next question.

WILL GIVE BRAINLIEST

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Do you know the correct answer?

On the handout draw the following circuits with schematic symbols. Label your answers circuit 1 and...