Engineering, 18.11.2020 16:50, carechiga24
Calculate the nominal values of torsional, axial, thread bearing, and thread shear stresses under
starting conditions for the power screws in Problems (a) 10.3, (b) 10.8, (c) 10.9, (d) 10.10, and
(e) 10.11. Assume in each case that the length of thread engagement is 1.5 times the outside diameter
of the screw.
10.3 A square-threaded power screw with single thread is used to raise a load of 25,000 lb. The screw
has a mean diameter of 1 in. and four threads per inch. The collar mean diameter is 1.5 in. The
coefficient of friction is estimated as 0.1 for both the thread and the collar.
(a) What is the major diameter of the screw?
(b) Estimate the screw torque required to raise the load.
(c) If collar friction is eliminated, what minimum value of thread coefficient of friction is needed
to prevent the screw from overhauling?
[Ans.: (a) 1.125 in., (b) 4138 lb • in., (c) 0.08]
10.10 An ordinary C-clamp uses a 1
2
-in. Acme thread and
a collar of 5/8 -in. mean diameter. Estimate the force
required at the end of a 5-in. handle to develop a
200-lb clamping force. (See Figure P10.10.)
Answers: 2
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10, niicoleassssssf
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
Engineering, 04.07.2019 18:10, salazjlove
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Calculate the nominal values of torsional, axial, thread bearing, and thread shear stresses under
s...
Physics, 15.04.2021 04:00
Mathematics, 15.04.2021 04:00
Mathematics, 15.04.2021 04:00
Mathematics, 15.04.2021 04:00
Mathematics, 15.04.2021 04:00
History, 15.04.2021 04:00