THESE POINTS ARE FOR
Gobo3 and skyoung237
...
![answer](/tpl/images/cats/otvet.png)
Answers: 1
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Do you know the correct answer?
Questions in other subjects:
![Konu](/tpl/images/cats/biologiya.png)
Biology, 07.01.2021 19:20
![Konu](/tpl/images/cats/biologiya.png)
Biology, 07.01.2021 19:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 07.01.2021 19:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 07.01.2021 19:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 07.01.2021 19:20
![Konu](/tpl/images/cats/informatica.png)
Computers and Technology, 07.01.2021 19:20
![Konu](/tpl/images/cats/mat.png)
Mathematics, 07.01.2021 19:30
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/biologiya.png)
Biology, 07.01.2021 19:30