Engineering, 06.11.2020 01:00, Malari4445

The essay or report should: Name the product and briefly describe it. Identify the types of engineering that would be used to develop the product. Describe how you would apply the stages of the product life cycle to your product. Generally describe the steps that you would take within each step, using your product as an example. End with a short conclusion based on what you believe the outcome would be if you followed the product development life cycle process. (I NEED IT FAST AND IT NEEDS TO BE ANYTHING AND IF YOU JUST PUT A RANDOM THING YOU WILL BE REPORTED AND JUST PLEASE PUT YOUR BEST ANSWER! ILL MARK YOU AS BRAINLIEST)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

Engineering, 04.07.2019 19:20, amcd2002

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

continue

Do you know the correct answer?

The essay or report should: Name the product and briefly describe it. Identify the types of engineer...