Engineering
Engineering, 02.11.2020 19:30, sam710

In the CS stage of the figure below, we have Rs = 200 , Ces = 250 fF, CGD =
80 fF, Coe = 100 ff, g. m= 150 ohm-1, lamda=o, and R = 2 ko.
Using the dominant pole
approximation, the 2 poles of the
circuit are found to be:


In the CS stage of the figure below, we

have Rs = 200 , Ces = 250 fF, CGD =80 fF, Coe = 100 ff, g

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
image
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
image
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
image
Engineering, 04.07.2019 19:10, shunna33
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
Do you know the correct answer?
In the CS stage of the figure below, we have Rs = 200 , Ces = 250 fF, CGD =
80 fF, Coe = 100 f...

Questions in other subjects:

Konu
Mathematics, 17.04.2020 20:35
Konu
Mathematics, 17.04.2020 20:35