Engineering
Engineering, 28.10.2020 17:00, arielcainess

A pre-engineering baseline was run down a very steep hill. Rather than measure horizontally downhill with the steel tape, the surveyor measures the vertical angle with a theodolite and the slope distance with a 200-ft steel tape. The vertical angle is -21° 26’ turned to a point on a plumbed range pole that is 4.88 ft above the ground. The slope distance from the theodolite to the point on the range pole is 148.61 ft. The theodolite’s optical center is 4.66 ft above the upper baseline station at 110 + 71.25. (a) If the elevation of the upper station is 318.71, what is the elevation of the lowerstation?

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
image
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
image
Engineering, 04.07.2019 19:10, kimmy6973
What is creep? what is stress relaxation?
Answers: 1
Do you know the correct answer?
A pre-engineering baseline was run down a very steep hill. Rather than measure horizontally downhill...

Questions in other subjects:

Konu
Mathematics, 10.02.2021 05:10
Konu
Mathematics, 10.02.2021 05:20
Konu
Mathematics, 10.02.2021 05:20