Engineering, 26.10.2020 16:40, layla07
(a) By applying the relevant knowledge, the Total Solidification Times(TST) of three casting shapes are to be calculated and compared: (1) a sphere with diameter 1β4 10 cm, (2) a cylinder with diameter and length both 1β4 10 cm, and (3) a cube with each side1β410 cm. The same casting alloy is used in the three cases. Determine the relative solidification times for each geometry. If the mold constant 1β4 3.5 min/cm2 in Chvorinov's rule, compute the total solidification time for each casting. (b) Based on the results of part (a), which geometric element would make the best riser and why? Present an analysis-based comment on the outcome.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, genyjoannerubiera
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30Β°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
Do you know the correct answer?
(a) By applying the relevant knowledge, the Total Solidification Times(TST) of three casting shapes...
Questions in other subjects:
Mathematics, 19.02.2020 02:51
Health, 19.02.2020 02:51
