Engineering, 23.10.2020 01:01, kaaylon8285

Your company wishes to write a computer program that will calculate the amount of heat needed to increase the temperature of a substance by a specified number of degrees. The company also wishes to know who ran the program and on what day of the week they ran it. You are to write this program. Your program must allow the user to enter the following:
The user’s name using a dialog box
Since the program will only be run either on Monday, Wednesday, or Friday, restrict the day of the week to these selections using a question dialog
The mass of the substance in units of grams
The specific heat of the substance in units of J/(kg K)
The initial temperature of the substance in units of degrees Fahrenheit
The final temperature of the substance in units of degrees Fahrenheit

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:10, nayi2002

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

continue

Engineering, 04.07.2019 19:10, lexie223

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

continue

Do you know the correct answer?

Your company wishes to write a computer program that will calculate the amount of heat needed to inc...