Engineering, 21.10.2020 08:01, christeinberg1

Due at 11:59pm please help Which of the items shown in the photo were developed using engineering design processes to develop a solution to a problem?

A. computer
B. coffee cup
C. table
D. pen

An engineer proposes that a newly developed chemical could be sprayed from aircraft to slow the rate of burning in a forest fire. What is the next step the engineer is likely to take to develop a solution to fighting forest fires?

A. test a number of similar chemicals

B. spray and compare the effectiveness of each tested chemical to water.

C. add the chemical to all aircraft spray tanks.

D. design a spray system for the chemical.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Engineering, 06.07.2019 02:30, josediaz1124

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

continue

Do you know the correct answer?

Due at 11:59pm please help Which of the items shown in the photo were developed using engineering d...