Engineering, 20.10.2020 16:01, rita53
Determine the maximum normal stress in the bracket at section a-a when the FFF = 141 kNkN load is applied at x=0x=0.
Answers: 1
Engineering, 04.07.2019 18:20, kendrawalraven
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 19:10, nhester3401
Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.
Answers: 2
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Determine the maximum normal stress in the bracket at section a-a when the FFF = 141 kNkN load is ap...
Mathematics, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00
Health, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00
History, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00
Mathematics, 10.12.2020 20:00