![answer](/tpl/images/cats/otvet.png)
Answers: 3
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Do you know the correct answer?
Ilove you is an example of?...
Questions in other subjects:
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/fizika.png)
![Konu](/tpl/images/cats/istoriya.png)
History, 12.11.2019 05:31
![Konu](/tpl/images/cats/informatica.png)
Computers and Technology, 12.11.2019 05:31
![Konu](/tpl/images/cats/biologiya.png)
![Konu](/tpl/images/cats/informatica.png)
![Konu](/tpl/images/cats/fizika.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/fizika.png)